Preparation And Processing
After the cane arrives at the mill yards, it is mechanically unloaded, and excessive soil and rocks are removed.
The cane is cleaned by flooding the carrier with warm water (in the case of sparse rock and trash clutter) or by spreading the cane on agitating conveyors that pass through strong jets of water and combing drums (to remove larger amounts of rocks, trash, and leaves, etc.)
At this point, the cane is clean and ready to be milled.
Juice Extraction Pressing
Two or three heavily grooved crusher rollers break the cane and extract a large part of the juice, or swing-hammer type shredders (1,200 RPM) shred the cane without extracting the juice.
Revolving knives cutting the stalks into chips are supplementary to the crushers. (In most countries, the shredder precedes the crusher.) A combination of two, or even all three, methods may be used.
The pressing process involves crushing the stalks between the heavy and grooved metal rollers to separate the fiber (bagasse) from the juice that contains the sugar.
As the cane is crushed, hot water (or a combination of hot water and recovered impure juice) is sprayed onto the crushed cane counter currently as it leaves each mill for diluting.
The extracted juice, called vesou, contains 95 percent or more of the sucrose present.
The mass is then diffused, a process that involves finely cutting or shredding the stalks. Next, the sugar is separated from the cut stalks by dissolving it in hot water or hot juice.
Purification Of Juice — Clarification And Evaporation
The juice from the mills, a dark green color, is acid and turbid. The clarification (or defecation) process is designed to remove both soluble and insoluble impurities (such as sand, soil, and ground rock) that have not been removed by preliminary screening.
The process employs lime and heat as the clarifying agents. Milk of lime (about one pound per ton of cane) neutralizes the natural acidity of the juice, forming insoluble lime salts. Heating the lime juice to boiling coagulates the albumin and some of the fats, waxes, and gums, and the precipitate formed entraps suspended solids as well as the minute particles.
The muds separate from the clear juice through sedimentation. The non-sugar impurities are removed by continuous filtration. The final clarified juice contains about 85 percent water and has the same composition as the raw extracted juice except for the removed impurities.
To concentrate this clarified juice, about two-thirds of the water is removed through vacuum evaporation. Generally, four vacuum-boiling cells or bodies are arranged in series so that each succeeding body has a higher vacuum (and therefore boils at a lower temperature).
The vapors from one body can thus boil the juice in the next one—the steam introduced into the first cell does what is called multiple-effect evaporation.
The vapor from the last cell goes to a condenser. The syrup leaves the last body continuously with about 65 percent solids and 35 percent water.
Crystallization is the next step in the manufacture of sugar. Crystallization takes place in a single-stage vacuum pan. The syrup is evaporated until saturated with sugar.
As soon as the saturation point has been exceeded, small grains of sugar are added to the pan, or “strike.”
These small grains, called seed, serve as nuclei for the formation of sugar crystals. (Seed grain is formed by adding 56 ounces [1,600 grams] of white sugar into the bowl of a slurry machine and mixing with 3.3 parts of a liquid mixture: 70 percent methylated spirit and 30 percent glycerin. The machine runs at 200 RPM for 15 hours.)
Additional syrup is added to the strike and evaporated so that the original crystals that were formed are allowed to grow in size.
The growth of the crystals continues until the pan is full. When sucrose concentration reaches the desired level, the dense mixture of syrup and sugar crystals, called massecuite, is discharged into large containers known as crystallizers. Crystallization continues in the crystallizers as the massecuite is slowly stirred and cooled.
Massecuite from the mixers is allowed to flow into centrifuges, where the thick syrup, or molasses, is separated from the raw sugar by centrifugal force.
The high-speed centrifugal action used to separate the massecuite into raw sugar crystals and molasses is done in revolving machines called centrifugals. A centrifugal machine has a cylindrical basket suspended on a spindle, with perforated sides lined with wire cloth, inside which are metal sheets containing 400 to 600 perforations per square inch.
The basket revolves at speeds from 1,000 to 1,800 RPM. The raw sugar is retained in the centrifuge basket because the perforated lining retains the sugar crystals.
The mother liquor, or molasses, passes through the lining (due to the centrifugal force exerted). The final molasses (blackstrap molasses) containing sucrose, reducing sugars, organic non sugars, ash, and water, is sent to large storage tanks.
Once the sugar is centrifuged, it is “cut down” and sent to a granulator for drying. In some countries, sugarcane is processed in small factories without the use of centrifuges, and a dark-brown product (non centrifugal sugar) is produced.
Centrifugal sugar is produced in more than 60 countries while non centrifugal sugar in about twenty countries.
Drying And Packaging
Damp sugar crystals are dried by being tumbled through heated air in a granulator. The dry sugar crystals are then sorted by size through vibrating screens and placed into storage bins.
Sugar is then sent to be packed in the familiar packaging we see in grocery stores, in bulk packaging, or in liquid form for industrial use.